We are culture science and a quest for design lorem ipsum dolor sit amet, consectetur adipiscing elit.

CLASSIC AUDITORIUM

Classic lecture hall seating based on steel columns with double shell seat and fixed or foldable tabletop.

CLASSIC FIX

Classic lecture hall chairs in stand construction with double shell seat and fixed table top.

 

Between each seat a support made of rectangular tube 40 x 25 mm below with half a floor plate and step bracket. Seat support made of 8 mm laser-cut sheet steel welded all round to the support. With double walled seat, 60 mm thick, consisting of lower and upper shell made of molded beech wood and solid beechwood sides, with or without an integrated counterweight. Ergonomically shaped backrest made of molded beech wood up to 20 mm above the upper edge of the table top. Two tip-up pivots made of PA6-Z1 plastic per seat with rubber-damped quadruple stop and lever made of solid steel (brazed) with or without return spring. All-around welded tabletop support. Fixed table top made of melamine resin coated chipboard 25 mm thick or multiplex top. Various design details and materials are selected and adapted on a project-specific basis.

CLASSIC ESB

Classic lecture hall chairs in stand construction with double walled seat and foldable desk top with scissor fittings.

 

Between each seat a support made of rectangular tube 40 x 25 mm below with half a base plate and step angle. Above with welded solid steel block and screwed and riveted cover of the supports with shelf strips. With double walled seat, 60 mm thick, consisting of an upper and lower shell made of molded beech wood and solid beech wood sides, with or without an integrated counterweight. Ergonomically shaped backrest made of molded beech wood up to 20 mm above the upper edge of the table top. Two pivots made of PA6-Z1 plastic per seat with rubber-damped quadruple stop and lever made of solid steel (hard-soldered) with or without return spring. Foldable table top made of melamine resin coated chipboard or multiplex board. Folding fittings with scissor hinge (inclined or horizontal). Various design details and materials are selected and adapted for each project.

CLASSIC PPA

Classic lecture hall chairs in stand construction with double shell seat and combined table unit made of fixed and foldable desk top.

 

Between each seat a support made of rectangular tube 40 x 25 mm below with half a base plate and step angle. Above with additional crossbars on the arm under the fixed table top part. Table cross member over several seats and screwed-on tip-up fittings type PPA. An offset arrangement can therefore also be easily implemented. With double walled seat, 60 mm thick, consisting of lower and upper shell made of molded beech wood and solid beech wood sides, with or without an integrated counterweight. Ergonomically shaped backrest made of molded beech wood up to 20 mm above the upper edge of the table top. Two pivots made of PA6-Z1 plastic per seat with rubber-damped quadruple stop and lever made of solid steel (brazed) with or without return spring. Table top part that can be folded upwards with laser-cut and riveted hinged fittings made of sheet steel with multiple stops in the angled fitting part. Table tops made of melamine resin coated chipboard or multiplex board. Various design details and materials are selected and adapted for each project.